PRINTED IN U.S.A.Operator’s ManualFORM NO. 770-10540C.fm(7/2003)IMPORTANT: Read safety rules and instructions carefully before operating equipment.MTD
10SECTION 6: MAINTAINING YOUR SNOW THROWERReplacing Belt• Remove the belt cover by removing five hex screws. See Figure 8.Figure 8• Pull up on the id
11SECTION 8: TROUBLESHOOTING GUIDENOTE: For repairs beyond the minor adjustments listed above, contact your nearest authorized servicerepresentative
1210SECTION 9: PARTS LIST FOR MODELS 285, E285, 295 & E2954139443535443544334342183142182010282241131121216729121725222819153069913312327CABLE TO
13NOTE: For painted parts, please refer to the list of colorcodes below. Please add the applicable color code,wherever needed, to the part number to
14Models 285, E285, 295 & E295REF.NO.PARTNO. DESCRIPTION1 710-04071 Carriage Screw, 5/16-18 x 1.02 710-0451 Carriage Bolt, 5/16-18 x.075 GR 13 712
15Models 285, E285, 295 & E295REF.NO.PARTNO. DESCRIPTION1 629-0071 Extension Cord2 710-0157 Hex Screw, 5/16-24 x .753 710-0409 Hex Screw, 5/16-24
MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the
2TABLE OF CONTENTSContent PageImportant Safe Operation Practices ... 3A
3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESDANGER: This machine was built to be operated according to the rules for safe operation in this manual.
45. Never run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas. 6. Do not operate
5SECTION 2: ASSEMBLING YOUR SNOW THROWERUnpacking From Carton• Cut along corners of the carton and lay it down flat. Remove packing material. • Remov
6SECTION 3: KNOW YOUR SNOW THROWERFigure 3Auger Control Handle Located on the upper handle, the auger control handle is used to engage and disengage
7SECTION 4: OPERATING YOUR SNOW THROWERBefore Starting • The spark plug wire was disconnected for safety. Attach spark plug wire to spark plug before
8To Stop Engine• To stop engine, turn ignition key counter-clockwise. Disconnect the spark plug wire from the spark plug to prevent accidental startin
9SECTION 5: MAKING ADJUSTMENTSShave Plate • To check the adjustment of the shave plate, place the unit on a level surface. See Figure 6. The wheels,
Comentários a estes Manuais